Track's pit

both dimensions depending on the rail you used and the gauge, a simple solution is to measure it with reference lines.

I've measured my rail with reference lines a while ago, it's hard and fiddling but doable.

If you are using the standard rail "rail_grooved_ph37 (SplinesBerlin)", the value of y should be 0.1265

For your x value you have to try because I'm not 100% sure, but it should be *gauge* - 0.148

Hey,

the values from Kira are correct. I'm a bit astonished, that you got the values from measuring with a reference line.

Greets

Florian As i said, it was hard and fiddling