Sänften animieren

Zitat von Marcel Kuhnt

In this case, A and B part should have two single-axle-bogies instead of one two-axle-bogie.

As I understood, it was necessary in section A and C (I have an extreme section called C) to replace the carts from two single-axle-bogiesl to two-axle-bogie. I did, but in the end everything also.

Maybe I wrote something wrong or maybe in the section "Animation" I made a structure incorrectly? So the cart even turns.

Or about "In this case, A and B part should have two single-axle-bogies instead of one two-axle-bogie." Did this mean the section "Animation"?

I made a really lousy model to test it by myself, but it worked.

Car C is the the middle section of the type "Railcar (levitating)"

A and B are front and rear and are normal railcars.

I found the difference between you two. Kira has set his A car as animation root, while karadamir has the middle section as root.

I have already changed several times. Well, in general, apparently the error is in the structure of the "animation". That is, from my side. I'll check the method that showed Kira.

But keep in mind that I have to change the script for a 4th bogie.

That is, the script will not support 4 uniaxial carts yet? Okay, wait, you still have to re-animate OZMT-19.

So, I again animated the car. Now 719A and 719C have “Railcar (normal)”, 719A have 0 and 1, 719C have 2 and 3. But I have a feeling that I again incorrectly built the structure in the section “Animation”, now my car starts move and eventually "flies" off the rail.

Although, I built sections as well as in Kira.