Content Tool error - cannot import modell

  • 1. Please describe as detailed as possible what you did and which problem that leads to.

    I remodelled a vehicle of mine, and try to import the new models, but I just can't.

    I exported from blender with these settings


    I import the model in CT, but this is what I got:


    Depending on the model, I get about 20-110 error messages like that, after that the two normal pop-up windows (flat shading and axises). And then no model is imported. On the right I see a list of objects, but nothing is drawn (not even if I change between file menus nor model modes - LOD, normal). Even if I try to save I can't.


    It doesn't matter if I try to import models to an absolutely new project (lob file) or an old one. Even if I exported a few polys of the model, I cannot import that...


    2. Please post your logfile and if possible attach your debug logfile, as well, which have been created during the problem occured.
    Here's the content tool logfile...which says absolutely the same thing, as the non-informative error message. Maybe you can see anything in it (thread for example), but I ddidn't get closer to the error.

  • Hmm, I would swear I used the settings above until now, but with switched-off triangulating it really helped. I guess it's been to long ago I converted models... :'D

  • Newly created posts will remain inaccessible for others until approved by a moderator.

    The last reply was more than 60 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.

    The maximum number of attachments: 5
    Maximum File Size: 500 kB
    Allowed extensions: bmp, cfg, ini, jpeg, jpg, lct, ldl, llg, lob, log, lpmtl, lptmt, ltx, pas, pdf, png, railtrack, rar, txt, veh, wav